Easy Tips for Irrigation Repair in Kent
Your sprinkler system does a great job of keeping your lawn, flowers, and plants fresh throughout the year. But an exterior system like this is subject to the stresses of outdoor rigors, including bad weather, temperature fluctuations, water pressure, tree roots, and burrowing animals. These are the most common unplanned events that cause the need for irrigation repair in Kent. Even outside of these events, many in-ground automatic sprinkler systems’ electronics can fail over time.
When
you find yourself in this predicament, follow these top three tips for
sprinkler and irrigation repair:
Replace a Sprinkler Valve
If
the sprinkler heads are not popping up or turning on, or if there is inadequate
water pressure, the problem may lie with the valves farther up the line. The
valves are like traffic controllers; they open and close as needed to send
water to pre-determined lawn areas. So when a valve is faulty, everything else
down the line is affected.
Replacing
valves can be an involved bit of irrigation repair,
requiring you to cut off the PVC pipes leading up to the valves. Some sprinkler
kits don't have a separate valve set, and the water runs directly through a
timer box, then out through the lines to the sprinkler heads.
Fix a Faulty Valve by Replacing the Solenoid
If
you've already ruled out water supply issues, then the fault might be a
solenoid. A solenoid is like a little door inside of the valve that opens and
closes in milliseconds. While solenoid replacement might sound complicated,
it's not. You'll find inexpensive replacement solenoids in most hardware stores
and online retailers. This irrigation repair takes about five minutes.
Winterize Your Sprinkler System
Since
your sprinkler system isn't needed during the winter, it's best to shut it
down. To properly winterize your sprinkler system: Do not leave the timer
pressurized. Remove the timer from the hose bib, drain and store it in a warm
and dry location. Drain the water from the system to prevent it from freezing
and blow out the remaining water through the system's blow-out port.
Comments
Post a Comment